Fiery Clone Tool 1.6
According to our registry, Fiery Clone Tool is associated with the file types listed below. It’s possible that Fiery Clone Tool can convert between the listed file. According to our registry, Fiery Clone Tool is associated with the file types listed below. It’s possible that Fiery Clone Tool can convert between the listed file.
Adobe Photoshop
I have an external Fiery controller working with a Xerox Color 570 printer. The PC is Windows 7 64 bit based. According to the 'Tech Note Fiery Clone Tool.pdf' document, only version 1.6 supports Win 7 64 bit.
When I try to run that version, I get an error (within Ubuntu and after saying I want to run with the attached mouse/kbd/display) that says: Fiery Clone Tool only supports genuine Fiery Hardware. Non-Fiery hardware has been detected. Fiery Clone Tool will now close. Needless to say.everything is as delivered by Xerox. OK.I'm going to have to show my ignorance as far as what I actually have! How/where do I look to determine exactly what I have so that I can put this question to rest?
As I said in the OP, I have an external PC as the Fiery controller mated with a Xerox Color 570 printer. (Everything was supplied by Xerox.) CW5 is version 5.7.0.29.
Healing Brush
I suspect there is more info needed to fully answer the question as to whether I can use the FCT. My goal: I want to fully clone the Fiery controller hard drive to act as backup protection. We've had to reload from scratch 2 or 3 times over the past couple of years.I want to try to avoid this if possible. I am open to the method.but would prefer the 'accepted/official' procedure. I assumed it was with a downloaded disk image for FCT but if not, I need some pointers please.